|Construction / tuning
Well, there is not much to explain for the assembly of this ARF! Apply the
decor on the wings - slide the wings into place - connect the servo with
the RX. Connect the rudder & elevator servo with the RX. Hook up the
rudders to the rods, glue the elevator wing in place - test all the settings!
Just follow the very good manual and you will get there in 15 minutes.
The longest was the soldering of the new plug to the BEC - fitting to my
2mm plugs for the small lipos!
The CG is achieved by sliding back and forward the lipo in the spacious
... still to come...
|All rights reserved by rcskyliner.com and its owner!